Plywood Boat Seat Base

plywood boat seat base

Re: what plywood for seat cushions? i had a 1996 bayliner. factory painted seat cushion plywood and side panel plywood rotted away in 2000. i replaced it with exterior plywood totally sealed with 2 coats of minwax spar varnish, about $10 from home depot. when i sold the boat 7 years later in 2007 all of the replaced wood still looked brand new.. This seat base is trashed, completely rotted. i don't even want to put it back in like it is. finally, remove the starboard side rear seat base in the bow. this one is in ok shape. it looks like it had some patchwork done to the plywood when the previous, previous owner had the interior vinyl done in what okie tells me was 2009.. A seat base should have bolts that go through wood floor and anchot to a square plate (usually alluminum) approximately as wide as seat base, this way any upward or sideways pressure is applied to a large area, not just the screw few threads through a 1/2" sheep to pluwood..

Pontoon Boat Flip-Flop Seat

Pontoon boat flip-flop seat

BOSTON WHALER STERN SEAT, FITS CLASSIC 16'/17 HULL OW

Boston whaler stern seat, fits classic 16'/17 hull ow

plywood boat seat base A boat seat with a standard 7" mounting pattern is designed to fit a suitable pedestal, swivel or slide. the seat base mounting holes will line up with the four equally-spaced slots mounting surface. the slots (marked in red) will align with holes on seat base from 110mm to 140mm. this pattern is the most commonly used pattern on marine chairs. Quick and cost-effective way to instal a swivel plate and boat seat in an old aluminum fishing boat. www.cottagetips.com..

 

Wood Boat Plans Copyright © 2011-2012 | Powered by Blogger